Off-Track Garage Door Reset: before you call

The door came down fine but with a scraping noise, and now the vertical track on one side is bowed away from the wall. Two screws have pulled out of the wood and the roller nearest the floor has no rail around it.

Worth answering before the call

Are the springs mounted above the door or stretched along the sides? Was the door frozen to the floor or was something under it when the opener ran? Did a vehicle or anything else bump the door before this happened?

Will the door be as good as it was before?

In most cases it comes back better, because the reset includes truing the track, replacing worn rollers and correcting the misalignments that had been building unnoticed. The exception is a section creased by an impact: it may work perfectly well after the reset yet keep a visible dent, and the technician will tell you whether it is sound or worth replacing at some point. You are shown the door running before the visit ends.

My car is trapped inside. Can I lift the door by hand to get it out?

Lifting a crooked door is where most injuries around this problem happen, because the springs and cables are loaded unevenly and the door can shift suddenly. Tell the technician on the phone that a vehicle is inside; getting it out is part of the plan, and the door will be supported and levelled before it is raised. A short wait is far cheaper than a bent section or a hand caught between panels.